Changing back to normal boot from sda3 the dmesg output from that point looks as follows:
Koen
EXT3 FS on sda3, internal journal EXT3-fs: mounted filesystem with writeback data mode. VFS: Mounted root (ext3 filesystem) on device 8:3. devtmpfs: mounted Freeing init memory: 180K wco.c:v0.01 10/02/2012 WriteCO Control Driver udev: starting version 151 ADDRCONF(NETDEV_UP): eth0: link is not ready set clk 1 to 64998375 dividers found (in lookup table) for Fout = 64998375. n=234 d=5 odiv 18 set internal refclk divider to 31.0.(accurate mode) set clk 1 to 148500148 dividers found (in lookup table) for Fout = 148500148. n=1188 d=25 odiv 8 DCON fb callback: blank... YC pitch is 0.User program needs refine YC pitch is 0.User program needs refine set clk 1 to 148500148 dividers found (in lookup table) for Fout = 148500148. n=1188 d=25 odiv 8 eth0: link up, 100 Mb/s, full duplex, flow control disabled ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready DCON fb callback: unblanking... eth0: link down eth0: link up, 100 Mb/s, full duplex, flow control disabled eth0: link down eth0: link up, 100 Mb/s, full duplex, flow control disabled eth0: no IPv6 routers present
Koen
